Baumatic BHI909TS.GWK - Manual (Page 13)

Touch controls
o
All operations are performed by means of the touch controls that
can be found on the control panel.
o
The controls respond to touch so you do not need to add any
pressure.
o
You should use the ball of your finger not the tip when using the
controls.
o
A beep will sound each time a touch is registered.
o
You should ensure that the controls are kept clean, dry and that
no objects such as utensils or cloths cover them. Even a thin film
of water may make the controls difficult to operate.
Switching the hob on
o
When the hob is connected to a power supply the control panel
will initialise for about 3 seconds. The LED lights will illuminate
and the controls will not be operational during this time. Once
the initialisation has completed the hob will go into stand-by
mode.
o
To turn the hob on you should press the ON/OFF
button.
o
NOTE: Only the ON/OFF button can be pressed
when turning the hob on. If the hob detects
any other key activation it will remain in
stand-by mode.
o
All of the cooking zone indicators will show “0” and the
dot in the bottom corner of each cooking zone selector
(2) will flash to indicate that no zone has been selected.
13