beautypg.com

Ignition system check – Baja Motorsports DR125 Operator's Manual User Manual

Page 28

background image

25

Ignition System Check

1. Remove the spark plug and reattach it to the spark plug lead.

2. Turn ignition key to the “RUN” position. Slide the engine stop switch

to the “Run” position. Push the electric button “START “(grey button).

If the ignition system is operating properly, a blue spark should jump

across the spark plug gap. If there is no spark, take your machine to your

service center.

COMPLAINT: Engine stalls
1. Make sure there is enough fuel in the fuel tank.
2. Check to see that the spark plug is not fouled. Remove the spark plug

and clean it. Replace it, if necessary.

3. Make sure the fuel valve is not clogged, and the fuel tank is not clogged,

either.

4. Check the idle speed. If necessary, adjust it using a tachometer. The

correct idle speed is 1400~1600 r/min.

5. Make sure the air filter is clean.

WARNING

Performing the spark test improperly could be hazardous.

You could get a high voltage electrical shock if you are not familiar with this

procedure.

Do not perform this check if you are not familiar with the procedure. Do

not point the spark plug near the spark plug hole during this test. Do not

do this test if you have a heart condition or wear a pacemaker. Do not

perform this test is any near any open fuel containers for near fuel which

has spilled on the ground, on the engine, or any part of the ATV.