Baja Motorsports DR125 Operator's Manual - Manual (Page 23)

20
ADJUSTING THE THROTTLE CABLE
Make sure the throttle works normally.
Check if the throttle twist grip has the required free operating movement.
The required free operating movement: 2-6mm (.078 inches - .24 inches) If
the grip cannot be moved freely, turn the adjusting nut located on top of the
throttle twist grip to ensure proper operating movement.
After adjustment, start the engine and check for the operating movement
again. Repeat the adjustment if necessary until the desired operating
movement is obtained.
ADJUSTING THE CARBURETOR
Adjusting procedures of idling speed:
1. Support the vehicle by a stand.
2. Adjust the idling speed by the throttle stop screw to 1500 ± 150rpm.
CAUTION
Do not try to correct a malfunctioning carburetor by adjusting the
idling speed. If the carburetor is not functioning properly, it should be
repaired by a service center.
Adjust idling speed only when the engine is warmed up or 10 minutes after
operation.
Idling speed
adjusting screw
Adjustment nut
!