beautypg.com

Changing the oil, cleaning oil filter screen, Check-up of spark plug – Baja Motorsports DR125 Operator's Manual User Manual

Page 20

background image

17

CHANGING THE OIL, CLEANING OIL FILTER SCREEN

1. Remove the oil drain plug, spring and oil filter screen located at the bottom

of the engine and let the oil drain into an approved collection container.

DO NOT PERFORM THIS PROCEDURE WHILE THE ENGINE IS HOT.

SERIOUS BURNS COULD RESULT FROM CONTACT WITH HOT OIL.

2. Dispose of the used oil properly. For proper disposal procedures, contact

your local oil recycling center

3. Clean oil screen and spring with solvent

4. Clean and replace the oil drain plug making sure it is secure.

5. Refill the engine with the proper amount of oil and recheck the amount of

oil in the engine by using the oil gauge plug and/or sight gauge.

CHECk-UP OF SPARk PLUG

1. Remove the cap of spark plug and screw off

the spark plug using the plug wrench.

2. Clean the spark plug all around or replace it

if it is corroded or there is too much deposit

on it.

3. Regulate the gap of the spark plug to 0.6-

0.8mm. (.024 inches - .032 inches)

The spark plug of the designated type

should be used. The applicable type of

spark plug: D8EA (NGk)

0.6~0.8mm

(.024 inches -

.032 inches)

Oil drain plug

Oil filter screen

Spring