Aviosys 9268 - Manual (Page 20)

Receiver Name: Receiver name is the Name of the Power Receiver that is selected. If no
name has been selected then it will be left blank
Receiver ID: Receiver ID is the physical address of the Power Receiver that is used by
the 9268-M to identify the device
Status: The status on the 9268 will show the following:
On: The 9268 Slave device has been setup correctly and is currently detectable
Off: The 9268 Slave device cannot be detected or is off
NA: There is no current device setup on that access Number
Control Center: The control center will show the following:
1.) The device cannot connect or has been turned off
2.) The device is connected and the master device can detect the device
RF Control Panel:
To control each of the 9268-PR Device click on the little satellite picture on the screen
and control panel for that unit will appear
’
(Satellite Picture)
- 20 -