Optional equipment, Lp conversion instructions – Avalon Firestyles Salish EF-2000 to 2001 User Manual
Page 32

30
Optional Equipment
Travis Industries
9 3 5 0 8 1 2 2
1 4 1 1 0 0
LP Conversion Instructions
Install the conversion kit prior to installing the gas line to ensure proper gas use.
1
Open the door (see page 16). Remove the logs and coals (if installed - page 17)
2
Remove the burner (see illustration below).
a
b
Remove the cast floor.
Reach into the firebox and lift the
burner upwards (lift the burner from
below).
Do not lift burner out by the pins.
WARNING:
The burner is fragile - handle it with care.
c
Pull the burner forward, out
of the firebox.
The tubes on the burner
insert into the tubes on the
mixing tube.
NOTE:
After replacing the burner,
make sure this “O” ring
seals the burner tube to the
mixing tube.
Mixing Tube
Burner Tube
Make sure the burner
is fully seated. When
in place, the pilot
flame must align
directly above the
burner holes.
Burner Replacement:
If the burner does not insert
easily, make sure the screws
holding the rear mixing tube
in place are slightly loose.
This allows the mixing tube
to move slightly and align
with the burner tube.