Finalizing the installation, Removing the glass, Creplacing the glass – Avalon Firestyles DVS Insert EF-2001 to 2005 User Manual
Page 17: Ab c d

Finalizing the Installation
1 7
© Travis Industries
4041213
1 0 0 - 0 1 1 5 0
1
Remove the glass (and arch covers) following the directions below.
Warning: The appliance must be completely cool before removing the glass.
Note:
If using an FPX arched face, attach the arch covers after installing the glass.
Cross Section of
Glass Attachment
Glass
Glass Gasket
(3/4" self-adhesive
channel gasket)
Glass Clip
Glass Clip
Attachment Studs
Face of Heater
Glass Clip Nuts
Loosen the nuts on the
top and side glass clips
until they are flush with
the end of the stud (do
not remove the nuts).
a
3/8" Nutdriver
b
While holding the glass,
loosen the nuts on the
bottom glass clip until
they are flush with the
end of the stud. Pivot
the glass forward and
remove.
Tighten the nuts on the
bottom glass clip first, then
the top, then the sides.
Removing the Glass
While holding the glass, slide the
side and top glass clips off.
c
Replacing the Glass
With the bottom glass clip in place and
the nuts flush with the end of the stud,
position the glass over the bottom clip
(do not tighten the nuts).
Replace the top glass clip
(do not tighten nuts).
Center the glass then
replace the side glass clips
(do not tighten nuts).
a
b
c
d