Avalon Firestyles DVS Insert EF-2001 to 2005 - Manual (Page 16)

1 6
Installation
(for qualified installers only)
© Travis Industries
4041213
1 0 0 - 0 1 1 5 0
Manifold Removal and Installation (Continued)
Remove the glass (see the instructions on page 17). Follow the directions below to remove the
manifold.
N O T E : When replacing the manifold, use the convection top to guide the manifold. You may also
reach through the exhaust ducts to guide the manifold forward to the appropriate location.
Remove the four bolts
inside the firebox.
7/16”
Socket
5/16" Nutdriver
Remove the three screws holding
the convection top to the insert.
Convection Top Manifold
Slide the
manifold
back.
NOTE: when installing the manifold, make
sure the gaskets sealing the inlet and exhaust
ducts are in place. If a gasket is loose, use
high-temperature silicone to secure it to the
manifold.
Shim the manifold legs if
installing into a fireplace
with a raised hearth.
The baffle is held in place with the
bottom bolts -- install the baffle in front
of the washers.
Electrical Connection
• Plug the power cord into a grounded 120 Volt outlet (do not remove the grounding pin).