Avalon Firestyles DVL Insert EF-2002 to 2005 - Manual (Page 33)

Optional Equipment
3 3
Travis Industries 4 0 4 1 0 2 8 1 0 0 - 0 1 1 5 1
4 Remove the pilot orifice following the instructions below. Replace with the propane pilot orifice
Lift the pilot hood
off the pilot
assembly.
5/32" Hex
Use a hex wrench to
unscrew the orifice.
Remove the orifice and replace with the LP orifice. Screw the
orifice all the way in and replace the pilot hood.
LP (Propane) Orifice
Orifice Identification:
NG (Natural Gas) Orifice
35
62
35
a
b
c
NOTE: when re-attaching,
this pin lines up with the
notch in the pilot hood.
5 Install the logs and embers.
6 Replace glass and face.
7 Remove the regulator from the front of
the gas control valve. Replace with the
propane regulator, using the new
gasket and screws included with the
regulator. NOTE: Leak test this
area after the heater is installed,
gas is connected, and the main
burner is lit.
8 Make the gas line connection, bleed the
gas line (if applicable), start the heater
and thoroughly leak-test all gas
connections and the gas control valve.
Check the pilot. Adjust if necessary.
WARNING: When lighting or re-lighting
the pilot, the glass must be
removed (see page 17).
Place the LP
label on the base
near the gas
control valve.
d
Remove and discard the three
screws using a slotted screwdriver
of Torx T-20.
NOTE: Make sure the
regulator gasket is correctly
aligned before installation.
Remove and discard the
regulator, diaphram, spring
and center post.
a
b Slotted
Screwdriver
(or T-20 Torx)
Install the LP regulator. Use
the screws included with the
LP regulator. Tighten to
approximately 25 Lbs. torque.
c
Slotted
Screwdriver
(or T-20 Torx)
Standard
Screwdriver
The pilot flame must contact the thermocouple and
thermopile (see the illustration below). Adjust the pilot up or
down as necessary.
To adjust the pilot flame, turn this screw. Clockwise
lowers the flame while counter-clockwise raises it.