Avalon Firestyles Small Flush Hybrid-Fyre - Manual (Page 18)

18 Fireplace Insert Installation
(for qualified installers only)
© Travis Industries 100-01342 4150521
Surround Panel Installation
Width Height Part#
Standard Size 38” (966mm) 25” (635mm) 96100409
The surround panel is installed after the
insert is in place with the flue attached.
Make sure to route the power cord and
rheostat wires through the notch in the
panel.
NOTE: The surround panel is not required.
If the fireplace opening is small enough, you
may wish to use the face only (see
dimensions below).
NOTE: When installing the panel, route the power cord and rheostat wires through the notch on the bottom of
the panel (right side). Route the catalytic temperature probe wire through the notch on the left side.
Make sure these wires do not become pinched or damaged during panel and face installation.
Face Installation and Removal
WARNING: Unplug or disable power
to the appliance prior to removing the
face.
1) Open the door and lift it off its
hinges.
2) Pull the bypass all the way forward.
Unscrew the bypass rod from the
bypass yoke (make sure to detach
the handle and rod as one piece).
3) Unscrew the air control rod from
the air control.
4) The face uses hooks to hang in
place. Lift the face up and pull
back to remove. Take care to
prevent damage to the wiring
(disconnect if necessary).
See the instructions included with the
face for full details.
FACE SIZING: 30” Wide, 21.5” Tall
When installing, lift the panel over this flange.