Avalon Firestyles Olympic - Manual (Page 17)

Fireplace Insert Installation
(for qualified installers only)
17
© Travis Industries 93508061 4150520
SAFETY NOTICE:
Please read this entire manual before you install and use your new room heater. Failure to
follow instructions may result in property damage, bodily injury, or even death. Contact
local building or fire officials about restrictions and installation inspection requirements in
your area.
Planning The Installation
We suggest that you have an authorized Travis Industries dealer install your fireplace insert. If you
install the fireplace insert yourself, your authorized dealer should review your installation plans.
Check with local building officials for any permits required for installation of this fireplace insert and
notify your insurance company before proceeding with installation.
Preparation for Installation
 Check for damage to the exterior of the fireplace insert (dents should be reported, scratches can be
fixed by applying touch up paint).
 Check the interior of the firebox (replace cracked firebrick and make sure baffle is in place).
The fireplace insert can be lightened by removing the firebricks and baffle (pg 38) - replace before
operation.
Additional Accessories Needed for Installation
 Surround Panels (see page 46)
Standard vs. Cook-Top Installations
The top air chamber extension is shipped separately with the heater (see the following page for details).
When installed, the unit is considered a “Standard Model” for Insert Placement and Fireplace Requirements.
If it is not installed, the unit is considered a “Cook-Top Model” for Insert Placement and Fireplace
Requirements.
Installation Considerations
Installation Type Considerations
Insert with Positive Flue (Full Reline)
(Page 22)
• Utilizes existing masonry fireplace
• Provides best draft
• Easiest to clean
Insert with Direct Connect Flue
(Page 22)
• Utilizes existing masonry fireplace
• Provides good draft
• Requires fireplace block-off plate - see page 21
Insert with Face Seal Connection
(Page 23)
NOTE: Before installing verify with local building
officials that this type of installation is
approved in your area.
• Utilizes existing masonry fireplaces with cross section
of 28" to 144"
• Provides marginal draft
• Easiest to install
• Requires the optional surround panels and insulation
(see "Surround Panels" on page 46).