Auto-Zone Control Systems CommLink 5 Technical Guide, Installation Instructions for the CommLink 5 Communications Interface (Version 01G) - Manual (Page 10)

CommLink 5 Technical Guide
10 Operator Interface
8. In the Network Confi guration selection box, select the
type of system confi guration you are using. Th e only
options applicable to CommLink 5 are Multiple Loop
Confi guration (Network) or Single Loop Confi guration.
9. Click to close out of the Job Sites Window.
10. Click the
button to go
.
11. From the menu, select
for Units>.
Prism 2 Setup Instructions
Prism 2 Setup
1. Open your Prism 2 soft ware.
2. Click the button and type in the level
3 User Name and password (default is “admin,
admin”). Click
.
3. If Prism 2 is online, click the
button to make it go
.
4. Click the
button to open the
Job-Sites Window .
5. Click on any empty location in the Job-Site Selection
Window and then type in a job name in the Selected
Location box and press .
6. In the Serial Port fi eld, click on the pull down box and
select
the COM Port number that the CommLink 5 is
using.
7. In the Type of CommLink selection box, select the radio
button next to CommLink 5.
Revised: 10/30/14