ATEIS Messenger Series - Manual (Page 13)

Messenger Operating Manual
Page 13 of 38
9.2. Input Settings tab:
If you are accessing a new Messenger (Factory Default) in the “input Settings” tab
the settings are as in the windows below.
9.2.1. Primary input:
INPUT SENSE Sets the input sensitivity of the primary input. By default this is
set to 0 dB.
LINE OUT Sets the output level to the next Messenger. By default this is
set to 0 dB.
VOLUME Sets the direct audio level of the primary input. By default this
is set to 0 dB.
NOISE GATE Is by default enabled and can be adapted to the situation by altering
the values in the boxes: Level, Hold and Soft fade (out).
PEAK LIMITER Is by default enabled and set at –3dB. It is our strong recommendation
that the peak-limiter stays enabled. It is for protection reasons. If high
SPL levels are required the limiter could be set to 0 dB. This will still
limits the audio at 0,1 dB before the AD converter starts clipping.
DELAY Maximum delay setting is 1000 ms.
MUTE Audio MUTE mutes the primary input. It does not mute the audio path
from the audio-slave output.