Artesyn System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User's Guide (June 2014) - Manual (Page 25)

Software Installation and Configuration
System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User’s Guide (6806800P20C) 25
MaxOutstanding
Maximum number of
outstanding IPMI
commands
<0…N> [10]
- 10 commands by default. After
this max is reached, any other request
is awaited.
0
PtpEKeyingMode
E-keying mode
<0,1,2> [2]
– Full e-keying. To do the e-key on
both local and remote ports
1
– Simple e-keying. To do the e-key
on only local ports
0
– Disable the e-keying
Full e-keying
ResourcePowerOffTimeout
A timeout after which
the resource FRU
Power State will be set
to initial state. This
timer is started soon
after executing the
Power Off/Power
Cycle/hotswap
operations on the
resource.
<0…N> [60000]
- 60000 ms
60000
ResourcePowerOnTimeout
A timeout after which
the resource FRU
Power State will be set
to initial state. This
timer is started soon
after executing the
Power On/hotswap
operations on the
resource.
<0…N> [20000]
- 20000 ms
20000
clear_sel
Clear the SEL after
reading events from it
"yes | no" [yes]
– clear the SEL
No
– Do not clear the SEL
yes
RmcpEnable
Enables/disables the
RMCP server
"true |
false" [true]
– enables the rmcp server
false
– disables the rmcp server
false
RmcpPort
Port on which RMCP
service runs
Standard port
[623] 623
RmcpMaxConnection
Maximum number of
connections active.
After this count is
reached, any new
connections are
rejected
<0…N> [10]
– 10 connections
10
RmcpConnectionTimeout
RMCP connection
timeout
<0…N> [60000]
- 60000 msecs
60000 msecs
RmcpSessionTimeout
RMCP Session
Timeout
<0…N> [60000]
- 60000 msecs
60000 msecs
RmcpPefAlerting
RMCP PEF alerting
"true |
false" [true]
- supports PEF alerting
false
- does not support
false
RmcpPerMsgAuth
RMCP per msg
authentication
"true |
false" [true]
- authentication supported
false
Table 2-4 Plugin Specific Parameters (continued)
Tag Description Allowed values Default in Config. file Built-in Default