Aplex Technology AHM-6077 User Manual
Page 26
AHM-6077 User Manual
26
hard disk partition table.
Enabled Activates automatically when the system boots up causing a warning message to appear when
anything attempts to access the boot sector of hard disk partition table.
Hard Disk Boot Priority
The selection is for you to choose the hard disk drives priorities to boot from.
Quick Power On Self-Test
This category speeds up Power On Self Test (POST) after you power on the computer. If this is set to
Enabled, BIOS will shorten or skip some check items during POST.
Enabled (default) Enable quick POST
Disabled
Normal POST
First/Second/Third Boot Device
The BIOS attempts to load the operating system from the devices in the sequence selected in these items.
The optional settings are：Removable; Hard Disk; CDROM; Network;Disabled..
Boot Up NumLock Status
The default value is On.
On (default) Keypad is numeric keys.
Off
Keypad is arrow keys.
Typematic Rate Setting
Keystrokes repeat at a rate determined by the keyboard controller. When enabled, the typematic rate
and typematic delay can be selected. The settings are: Enabled/Disabled.
Typematic Rate (Chars/Sec)
Sets the number of times a second to repeat a keystroke when you hold the key down. The settings are:
6, 8, 10, 12, 15, 20, 24, and 30.
Typematic Delay (Msec)
Sets the delay time after the key is held down before beginning to repeat the keystroke. The settings are
250, 500, 750, and 1000.
Security Option
This category allows you to limit access to the system and Setup, or just to Setup.
System The system will not boot and access to Setup will be denied if the correct password is not entered
at the prompt.
Setup (default)
The system will boot, but access to Setup will be denied if the correct password is not
entered prompt.
MPS Version Control for OS 1.4
This option is only valid for multiprocessor motherboards as it specifies the version of the Multiprocessor
Specification (MPS) that the motherboard will use.
OS Select for DRAM > 64MB
Allows OS2
to be used with >64MB or DRAM. Settings are Non-OS/2 (default) and OS2. Set to OS/2
if using more than 64MB and running OS/2
.
HDD S.M.A.R.T Capability
This option allow you to enable the HDD S.M.A.R.T Capability (Self-Monitoring, Analysis and Reporting
Technology) . You can choose from Enabled and Disabled.