Aplex Technology APC-3218 - Manual (Page 87)

APC-3X18 User Manual 87
Chapter 5 Touch Screen Installation
This chapter describes how to install drivers and other software that will allow your
PenMount 6000 Controller Board to work with different operating systems.
NOTE: PenMount USB drivers support up to 15 USB controllers.
5.1 Introduction to Touch Screen Controller Board
PenMount 6300 USB control board is a touch screen control board designed for USB
interface and specific for 4, 5, 8-wire touch screens. It is designed with USB interface
features with multiple devices supporting function. PenMount 6300 control board
using PenMount 6000 controller that has been designed for those who may like and
all-in-one solution with 10-bit A/D converter built-in to make the total printed circuit
board denser, circuit diagram also designed for 12-bit ADC for optional. There are
two connectors on this board, one connector is for 4, 5, 8-wire touch screen cable
(optional), and another is for 4-pin USB A type cable (optional).
Figure 5.1: Bird’s Eye View of Control Board