Aplex Technology APC-3793P - Manual (Page 15)

APC-3x93P_R (SBC-7106A) User Manual 15
Procedures of CMOS clear:
a) Turn off the system and unplug the power cord from the power outlet.
b) To clear the CMOS settings, use the jumper cap to close pins 1 and 2 for about 3
seconds then reinstall the jumper clip back to pins open.
c) Power on the system again.
d) When entering the POST screen, press the or key to enter CMOS Setup
Utility to load optimal defaults.
e) After the above operations, save changes and exit BIOS Setup.
Model JP3
SBC-7106A-N26 No
SBC-7106A-D25 Yes
SBC-7106A-D25P Yes
6. BAT1:
(1.25mm Pitch 1x2 box Pin Header) 3.0V Li battery is embedded to provide power for
CMOS.
Pin# Signal Name
Pin1 VBAT
PIN2 Ground
7. DC_IN1:
(5.08mm Pitch 1x3 Pin Connector),DC9V~32V System power input connector.
Pin# Power Input
Pin1 DC+9V~32V
Pin2 Ground
Pin3 FG
Model DC_IN1
SBC-7106A-D25 180°Connector
SBC-7106A-D25P 45°Connector
SBC-7106A-N26 180°Connector
8. BT1/BT2:
Power on/off button, They are used to connect power switch button. The two pins are
disconnected under normal condition. You may short them temporarily to realize system
startup & shutdown or awaken the system from sleep state.