Dynalink RTA210 - Manual (Page 3)

Default Configuration for New Zealand
We have pre-configured this router to the following settings. If you accept the
settings, please move on to Section 2 "Installing the Router".
Router IP address 192.168.1.1
Subnet mask 255.255.255.0
VPI 0 (do not change)
VCI 100 (do not change)
Encapsulation PPPoA VC-MUX (do not change)
Operating mode G.dmt (do not change)
NAT enabled (do not change)
WAN IP dynamic
DHCP off
DNS relay off
Router configuration and management:
User name
admin
Password private
Telnet password private
Users must not change VPI, VCI, Encapsulation and Operating Mode settings.
Advanced users who have other setup preferences should refer to the ADSL
Router User Manual on the provided CDROM.
Installing the Router
IMPORTANT- Before you start
Make sure your computer has these installed:
Network interface card (NIC)
TCP/IP protocol.
Other than attaching to a host computer the router can be connected to an uplink
port of a network hub. If the hub has no uplink port available, a cross-over
Ethernet cable must be used. This cable is not provided.
A web browser is required to enter your Internet account user name & password.
Make sure your web browser is Internet Explorer 5.0/Netscape 6 or better. Install
either Explorer 5.5 or Netscape 6 from the provided CDROM if your computer
does not have a suitable browser.
Remember to obtain these from your ISP:
Login user name and password
Public IP address (only if you subscribe for static IP)
DNS server IP.
1
2
ADSL Router Quick Set-up Guide