American Time Wireless Remote Transmitter - Manual (Page 20)

© American Time
20
Wireless Remote Transmitter Installation Manual
Glossary
Appendix
Tr
oubleshooting
Clock
Installation
Transmitter and System Setup
Intr
oduction
Remote Transmitter Connect
Web Interface
MTM Tab:
Figure 8
1. Set MTM To: This allows the user to enable or disable the Transmit to Wireless Master Clock Synchronizer. The Update button must be
pressed for this change to take effect.
2. Transmit Duration: This displays the amount of time that the contact closure is enabled. n Note: Only values from 1-9 seconds are valid
entries. The Update button must be pressed for this change to take effect.
3. Sync Time: This displays the time of day that the synchronized time pulse is sent. The pulse is only sent once a day and is programmed to
the nearest minute. The Update button must be pressed for this change to take effect.
Messaging Tab:
The Messaging Tab allows for the entry and storage of 10 pre-canned messages. These messages can be sent to message boards throughout
the facility.
Figure 9
1. Cap Code: The Cap Code must be match the Cap Code of the device receiving the message.
2. Message: The message entered may need to follow a certain format. Reference the message board reception format.
3. Description: This allows the user to enter a description of their message.
4. Enabled: Check this box and press Update to transmit the message.