Zilog ZAURA868 - Manual (Page 39)

ZAURA RF Module Shell
User Manual
UM023502-0911 tx
33
tx Send text message
Syntax
Tx dst message
Example
tx 1b hello 3

Transmit DA 1B Data: hello

The tx (transmit) command is used to send a text message to a remote
node. The target node is specified by the parameter, which should
be a hexadecimal value between
0x01 and 0xFF (broadcast to all nodes
in range).
The message parameter is an arbitrary string of ASCII characters. To
transmit messages with spaces, enclose the message in quotation marks
(e.g., “message with spaces”). The parameter is optional. If
is omitted, the message will be sent only once. If is
included, it must be between
0x00 and 0xFF . A non-zero value means
that the message will be sent times. If is zero, the mes-
sage will be transmitted continuously. Continuous transmission termi-
nates after the operator presses a key on the terminal program.