Per send bursts of 100 test packets to target – Zilog ZAURA868 User Manual
Page 28
ZAURA RF Module Shell
User Manual
UM023502-0911
per
22
per
Send bursts of 100 test packets to target
Syntax
per
Example 1
Per
Target 7F should be running 'RX' command
Polling 7F Index 0000 RxCount 100 on cycle 0
Polling 7F Index 0001 RxCount 100 on cycle 1
Polling 7F Index 0002 RxCount 100 on cycle 2
Example 2
per 23
Target 23 should be running 'RX' command
Polling 23 Index 0000 ... no response
Polling 23 Index 0000 ... no response
Polling 23 Index 0000 ... no response
The
per
and
rx
console commands are intended to be used together to
test the performance of the link. The node that runs the
per
command
sends bursts of 100 packets to the target node. This target node may be
explicitly identified using the
is not specified, the performance test frames will be sent to the default
ZAURA RF Wireless Module target address
RfDest
(DST command).
After transmitting 100 packets, the node running the
per
command polls
the target for a response frame. The objective is to determine how many
performance test frames the target actually received since the last time it
was polled. If there are no link errors, the target response should indicate
that 100 packets were received. If a response is received within approxi-
mately 100 ms, the number of test packets received by the remote target is
displayed. In this instance, the transmitter increments an index counter