Zilog ZAURA868 - Manual (Page 14)

ZAURA RF Module Shell
User Manual
UM023502-0911 remote
8
remote Issue command to remote node(s)
Syntax
remote cmd
Example 1
remote addr

local address: 1b
Example 2
remote rnvs 0 6

02 11 22 00 00 1B
Example 3
remote tx ff Hello

Rx Packet: RSSI 8A Pwr -49 dBm

05 FF 1B 00 68 65 6C 6C 6F

Transmit DA FF data: hello
Done transmit

The remote command is used to transmit a shell command to the default
ZAURA RF Wireless target address (DST command). The command is
not echoed on the remote terminal. In Example 3 above, the local node
will send a request to the remote node to issue a transmit request of
"Hello" to the broadcast address. The Remote node’s command inter-
preter will process the shell command ( tx ff Hello ) and transmit the
packet. When the local node receives the transmitted packet from the
remote node, it displays the received packet from the remote node.
Prior to initiating a remote shell command, the default ZAURA RF Wire-
less Module target address should be set to a unique address. If the broad-
cast address (
ff ) is used, the node issuing the remote console command