XTA 5 Series User Manual
Page 18

Page 18
5 Series
5 Series
5 Series
5 Series Operator’s Manual
Free Assign Routing
If none of the preset configurations are appropriate to the required system setup, it is possible to manually select the
routing of the crossover. This is achieved through the
Crossover Menu
Crossover Menu
Crossover Menu
Crossover Menu ----> Design A Crossover
> Design A Crossover
> Design A Crossover
> Design A Crossover
.
Pressing ENTER will start the crossover design wizard, with the first option being to choose the routing.
The display will show
Design A
Design A
Design A
Design A
Crossover
Crossover
Crossover
Crossover ---->
>
>
>
Routing = 2 X 4 WAY *
Routing = 2 X 4 WAY *
Routing = 2 X 4 WAY *
Routing = 2 X 4 WAY *
or whatever the current configuration is set to. Press BACK until the display shows
Design A Crossover
Design A Crossover
Design A Crossover
Design A Crossover ---->
>
>
>
Routing = Free Assign
Routing = Free Assign
Routing = Free Assign
Routing = Free Assign
And then press ENTER. The EDIT key will illuminate for output 1, as will any relevant input EDIT keys, showing which
inputs are feeding output 1. The display will also detail the current combination of inputs feeding this output. To change
the routing for any output, press its EDIT key, and then choose the required input channel combination by just pressing
the input EDIT keys as appropriate. The input combinations can also be stepped through in turn by pressing NEXT, or
BACK.
To complete the procedure, press ENTER. The wizard will continue, and if the routing has been changed, all outputs will
be muted on exit.
Full Matrix Mixing
If the free assign mode still isn’t flexible enough (!), it is possible to manually select the routing of the crossover with full
level mixing from any input to output. This is achieved through the
Cr
Cr
Cr
Crossover Menu
ossover Menu
ossover Menu
ossover Menu ----> Design A Crossover
> Design A Crossover
> Design A Crossover
> Design A Crossover
Pressing ENTER will start the crossover design wizard, with the first option being to choose the current routing.
The display will show
Design A Crossover
Design A Crossover
Design A Crossover
Design A Crossover ---->
>
>
>
Routing = 2 X 4 WAY *
Routing = 2 X 4 WAY *
Routing = 2 X 4 WAY *
Routing = 2 X 4 WAY *
or whatever the current configuration is set to. Press BACK until the display shows
Design A Crossover
Design A Crossover
Design A Crossover
Design A Crossover ---->
>
>
>
Routing = Full Matrix
Routing = Full Matrix
Routing = Full Matrix
Routing = Full Matrix
To complete the procedure, press ENTER. The wizard will continue, and if the routing has been changed, all outputs will
be muted on exit.
Matrix routing levels are stored in crossover memories (as with routing settings).