beautypg.com

WaveWare Adaptive Alpha Series Sign User Manual

Page 4

background image

4

7080C

(15 lbs, 6.8 kg)

7120C

(20 lbs, 9 kg)

7160C

(26 lbs, 11.8 kg)

7200C

(32 lbs, 14.5 kg)

Model

(weight)

Mounting instructions

Wall

Ceiling

Counter

NOTE: Do NOT install the sign directly to drywall or plasterboard. The sign

must be fastened to a wall capable of supporting at least 250 pounds
(113.3 kg).

NOTE: Keep a minimum 1.0-inch (2.54 cm) clearance on all sides of the sign

for adequate ventilation.

1. Remove the end cap from each side of the sign by unscrewing the two screws that

hold each end cap to the sign:

2. Stick two rubber “bumpers” to the bottom of each sign bracket. The bumpers

should end up between the sign bracket and the sign.

Place four screws through the bottom of each bracket. Then screw a nut onto each.

Slide the screw heads on each bracket into the two “channels” on the sign.

Position the brackets where you want them. Then tighten the screws using a 9/32”
(7 mm) socket wrench.

Bumpers

Channels

Sign bracket

3. Attach two brackets to a wall. The distance between these brackets will depend on

how far apart you spaced the sign brackets.

5. Tilt the sign to select a viewing angle. To hold the sign in place, insert a cotter

pin into the small holes located on each bracket (see arrows).

4. Connect the sign

brackets to the wall
brackets using the two,
large bolts supplied.

1. Remove the end cap from

each side of the sign by
unscrewing the two screws
that hold each end cap to the
sign (see the wall mounting
instructions).

2. Insert a mounting bracket

(shown below) into the “rail”
on each side of the sign.

3. Slide the mounting brackets

to the desired locations.
Then use the suppled screws
to fasten each mounting
bracket to the sign.
Use a chain (not supplied) to
hang the sign from a ceiling.

NOTE: Choose a chain and

mounting system
capable of
supporting a
minimum of 250
pounds (113.3 kg).

NOTE: Keep a minimum

1.0-inch (2.54 cm)
clearance on all
sides of the sign for
adequate ventilation.

NOTE: Keep a minimum

1.0-inch (2.54 cm)
clearance on all
sides of the sign for
adequate ventilation.

The sign will stand up if placed
on a counter.