WaveWare Adaptive Alpha Series Sign - Manual (Page 3)

3
4120C
4120R
(18.5 lbs, 8.4 kg)
4160C
4160R
(24.5 lbs, 11.2 kg)
4200C
4200R
(31 lbs, 14.1 kg)
4240C
4240R
(37.5 lbs, 17 kg)
Model
(weight)
Mounting instructions
Wall Ceiling Counter
1. Attach two wall brackets to a wall the
following approximate distance apart
(measured from the center of each bracket):
4120C / 4120R: 34” (86.4 cm)
4160C / 4160R: 46” (116.8 cm)
4200C / 4200R: 57-7/8” (147 cm)
4240C / 4240R: 69-7/8” (177.5 cm)
2. Stick two rubber “bumpers” to the bottom of each sign bracket. The bumpers
should end up between the sign bracket and the sign. Then use four screws to
attach each sign bracket to the sign.
4. Tilt the sign to select a viewing angle. To hold the sign in place, insert a cotter pin
into the small holes located on each bracket (see arrows).
NOTE: Do NOT install the sign directly to drywall or plasterboard. The sign
must be fastened to a wall capable of supporting at least 250 pounds
(113.3 kg).
NOTE: Keep a minimum 1.0-inch (2.54 cm) clearance on all sides of the sign
for adequate ventilation.
3. Connect the sign
brackets to the wall
brackets using the two,
large bolts supplied.
Bumpers
1. Remove the end cap from
each side of the sign by
unscrewing the two screws
that hold each end cap to the
sign:
2. Insert a mounting bracket
(shown below) into the “rail”
on each side of the sign.
3. Slide the mounting brackets
to the desired locations.
Then use the suppled screws
to fasten each mounting
bracket to the sign.
Use a chain (not supplied) to
hang the sign from a ceiling.
NOTE: Choose a chain and
mounting system
capable of
supporting a
minimum of 250
pounds (113.3 kg).
NOTE: Keep a minimum
1.0-inch (2.54 cm)
clearance on all
sides of the sign for
adequate ventilation.
1. Stick two rubber “bumpers”
on each mounting bracket.
The bumpers should end up
between the bracket and the
sign.
2. Attach each mounting bracket
to the sign using two screws
(supplied) per bracket:
Bumpers
3. Either rest the sign on the
mounting brackets or fasten
the brackets to the counter.
NOTE: Keep a minimum
1.0-inch (2.54 cm)
clearance on all
sides of the sign for
adequate ventilation.