WaveWare Adaptive Serial LED Clock - Manual (Page 9)

ALPHA Serial Clock Manual
3
Setting the time
To set the time of the master clock, use the HOUR or MINUTE
buttons on the front lower right side of the clock (See Figure 2: Serial
Clock—Front Panel). The HOUR and MINUTE buttons do not operate if
the clock is set to slave mode.
To set the hours, press the HOUR button until the desired number is
displayed. There is no AM/PM option. If the clock is in 12-hour mode, 1-
12 will be the only hours displayed. If the clock is in 24-hour mode, 0-23
will be the hours displayed. Use the 12/24 Hour Switch on the back of the
clock (See Figure 1: Serial Clock—Rear Panel on page 1) to set the clock to
either 12-hour or 24-hour mode.
To set the minutes, press the minute button until the desired number
is displayed. Each press of the HOUR or MINUTE button will increase
the number displayed by one. Pressing and holding the HOUR or
MINUTE button down will increase the numbers displayed
automatically.
Bright/Dim switch
A bright/dim switch, located on the back of the clock (See Figure 1:
Serial Clock—Rear Panel on page 1), allows you to switch between a
bright or a dim display mode to suit your preference.
Stand alone operation
Clocks not attached to a network must be set to master mode. The
time can be set using the HOUR and MINUTE buttons on the front of the
clock.
Figure 2: Serial Clock—Front Panel
HOUR
Button MINUTE
Button