Vectronics DL-2500 - Manual (Page 2)

DL-2500 High Power Dummy Load Owner's Manual
2
BEFORE USING YOUR DL-2500 DUMMY LOAD, PLEASE INSTALL THE
FOUR (4) RESISTORS FOUND IN THE SHIPPING CARTON!
INSTALLATION PROCEDURE:
1. Remove the top cover.
2. CAREFULLY unwrap the resistors. NOTE: The resistors are made of a fragile
ceramic material - use caution when handling.
3. Install the resistors into clips as shown in Figures 1 and 2 above. Hold the resistor in
the middle and press it firmly and evenly into its clip. Insert the middle resistors first.
4. Replace the cover noting the position of the connector identification on top.
TECHNICAL ASSISTANCE
If you have any problem with this unit first check the appropriate section of this manual.
If the manual does not reference your problem or your problem is not solved by reading
the manual you may call VECTRONICS at 601-323-5800. You will be best helped if you
have your unit, manual and all information on your station handy so you can answer any
questions the technicians may ask.
You can also send questions by mail to VECTRONICS, 1007 HWY 25 South, Starkville,
MS 39759 or by Fax to 601-323-6551. Send a complete description of your problem, an
explanation of exactly how you are using your unit, and a complete description of your
station.