TVLogic TDM-243W - Manual (Page 18)

18 Multiformat 3D Monitor
[4] GPI
5. Menu Operations
- The selectable values are as follows : • MONITOR ID
- Sets the ID of each monitor for the TV Logic
control protocol or DYNAMIC UMD using RS-
422/485 communication.
- Available values are between 0, 1, 2 ~ 125.
• UMD DISPLAY
- Used to set input source ID mode.
- Available modes are OFF, UMD, ANC,
D-UMD(S-8C), D-UMD(S-16C) and D-UMD(D-8C).
- If UMD menu is selected, characters or tally
data in the black bar displays on the bottom
of the screen. The vertical aspect ratio of the
image changes on the screen as the bar on
the bottom of screen appears.
- In the USER ASPECT mode, the UMD bar
displays semi-transparently and the screen
keeps its USER ASPECT ratio.
* UMD : Displays user customized 8 characters
on screen.
* ANC : Displays characters embedded in SDI
signal.
* D-UMD(S-8C) : Displays incoming data of 8
characters and tally signal from TSL protocol
(V3.1).
* D-UMD(S-16C) : Displays incoming data of
16 characters and tally signal from TSL protocol
(V3.1).
* D-UMD(D-8C) : Displays incoming data of two
pairs of 8 character strings and tally signals
from TSL protocol (V3.1).
• UMD CHARACTER
- Customizes the characters for Under Monitor
Display.
- Alphabets, numbers and special symbols are
available.
- Maximum of 8 characters are available.
PAGE II >> PAGE III
MONITOR ID
UMD DISPLAY
UMD CHARACTER
D-UMD TALLY TYPE
TALLY 1 COLOR
TALLY 2 COLOR
TALLY 3 COLOR
TALLY 4 COLOR
0
OFF
CHANNEL L1
TDM-243W
Menu
Classifi-
cation
Settable Values
PIN
1~6
NONE, HDMI CHANNEL, SDI
CHANNEL, 3D MODE, 2D MODE,
TALLY R, TALLY G, TALLY Y, UNDER
SCAN, 1:1 SCAN, ASPECT, H/V
DELAY, BLUE ONLY, MONO, 16:9
MARKER, 4:3 MARKER, 4:3 ON
AIR MARKER, 15:9 MARKER, 14:9
MARKER, 13:9 MARKER, 1.85:1
MARKER, 2.35:1 MARKER, 1.85:1&4:3
MARKER, CENTER MARKER, SAFETY
AREA 80%, SAFETY AREA 85%,
SAFETY AREA 88%, SAFETY AREA
90%, SAFETY AREA 93%, SAFETY
AREA 100%, 708, 608(LINE 21),
608(ANC)
PAGE I >> PAGE II
GPI 1
GPI 2
GPI 3
GPI 4
GPI 5
GPI 6
GPI 7
GPI 8
HDMI CHNNEL
SDI CHANNEL
3D MODE
2D MODE
TALLY R
TALY G
POWER ON
GND
TDM-243W