beautypg.com

Controls & functions – TVLogic TDM-243W User Manual

Page 10

background image

10 Multiformat 3D Monitor

3. Controls & Functions

• [SCAN] Button/Lamp

- Used to change the scan mode. Press the

button to activate through the scan modes:

OVER SCAN -> ZERO SCAN -> UNDER SCAN ->

2:1 SCAN -> 1:1 SCAN -> FIT WIDTH

* See section “Other Functions [1]SCAN Mode”

for more information.

• [MARKER] Button/Lamp

- Used to activate/deactivate the marker.

- The desired aspect ratio can be displayed on

the screen properly when the type of marker

selected from the main menu.

- If AFD is selected on the main menu, marker

automatically activates when input signal

contains the embedded AFD data.

• [APERTURE] Knob (TDM-243W)

- Used to adjust the picture sharpness.

- The value is selectable between 0 ~ 25.

• [BRIGHT] knob (TDM-243W)

- Used to adjust the degree of brightness.

- The value is selectable between -100 ~ 100.

• [CONTRAST] knob (TDM-243W)

- Used to adjust the contrast.

- The value is selectable between -100 ~ 100.

• [MENU] Button

- Used to activate/ deactivate the main OSD Menu.

• [DOWN]/[UP] Button

- Used to select Main menu and submenu.

- Used to increase/decrease the value of

selected feature.

• [ENTER] Button

- Used to enter submenu and see the feature

selected.

- If the source image is larger than the resolution

of the screen in 1:1 SCAN Mode, press this

button to move the position of the image.

*See section “Other Functions[1]SCAN Mode”

for more information.

• [OPERATE] Lamp

- Indicates condition and power status of unit.

- Light turns off when the power is disconnected.

- Standby mode is indicated by a red LED light.

- Normal (active) mode is indicated by a Green

LED light.

- Restores to previous state when monitor

power turns off and comes back on.

• [POWER] Button

- Used to turn power on and off.

• [TALLY] Lamp

- Tally lamp that can be toggled in green or red

using the REMOTE(RJ-45) port.

This manual is related to the following products: