Thrustmaster F430 FFB - Manual (Page 6)

5/12
CONFIGURING THE PEDAL SET
By default, your racing wheel's accelerator and brake controls operate in "Separate" mode; this setting
means that the pedals operate on independent axes.
This mode considerably improves precision when racing.
If your game is not compatible with the "Separate" mode, the pedal set connected to your racing wheel will
not operate correctly. You will then need to exit the game and select the "Combined" mode (in which both
pedals operate on the same axis).
PEDAL SET MODE
SEPARATE
(This mode is recommended for most games)
RED
COMBINED GREEN
• SETTING THE PEDAL BASE MODE USING THE SOFTWARE
(This setting is stored in the device's memory, even after you restart your computer or disconnect and
reconnect your racing wheel.)
- On Page 1 of the Control Panel interface: select the required mode, then click OK.
• SETTING THE PEDAL BASE MODE USING THE HARDWARE
(This setting is not stored in the device's memory: it must be performed every time you start your
computer
up or disconnect the racing wheel.)
- Simultaneously press and release: both pedals (accelerator and brake) and the Force button (2).
NOTE:
If your game is not compatible with the pedal base's "Separate" mode,
we recommend you switch your racing wheel to the "Combined" mode.