Thor HD Video Encoder & DVB-S2 Modulator - Manual (Page 18)

THOR H-1SDI-DVB-S2
~ 15 ~
Chapter 4 NMS Settings
H-HDSDI-DVBS2 Encoder Modulator adopts web-based user interface, NMS
GUI. Before operating, you should ensure that the computer’s IP address is
different from the DVB-S2’s IP address; otherwise, it would cause an IP
conflict.
4.1 Login
The default IP of this device is 192.168.0.136. We can change the IP from the
front panel of the device. Then connect the pc to the device with RJ45 Cable,
and use ping command to confirm these two are in same Network or not. If the
PC IP address is 192.168.99.252, we change the Device IP to 192.168.99.196,
then we need to use the Web browser to connect the device with our PC.
Put the IP address of the unit in the any internet browser and press Enter.
You should input the user name and password (The default Username and
Password is ‘admin’ and ‘admin’ respectively) then click on ‘Login’ to enter the
welcome interface which is shown as follows: