Dukane Data Video Projector 8103H - Manual (Page 8)

7
ENGLISH
7. Preparing for the remote control
The accessory remote control needs batteries. Use the batteries
included in this product or two new batteries of the specified
type: HITACHI MAXELL, part number LR6 or R6P. Follow
the following procedure.
1. Remove the battery cover in the back of the remote
control.
2. Put the batteries into the battery holder, according to the
polarity markings (+) and (-) inside the holder.
3. Put the battery cover back to the former state.
Remote sensors
3 m
(approx.)
NOTE
• Try changing the batteries when the remote control
malfunctions.
• This remote control works with the remote sensors
on the projector using infrared light (Class 1 LED).
The active sensor senses the remote control signal
assigned within 60 degrees to right and left, and
within 3 meters. For details, see the Operating
Guide in the CD.
• Prevent the remote sensors from being hit by a
strong ray. It may cause malfunction of the projector
and remote control.
WARNING
■ Be careful of handling a battery, as a battery can cause explosion, cracking or leakage,
which could result in a fire, an injury, and environment pollution.
• Use only the specified and new battery. Do not use a battery with damage, such as a
scratch, a dent, rust or leakage. Do not mix a new battery with used one.
• When a battery leaked, wipe the leakage out well with a waste cloth. If the leakage
adhered to your body, immediately rinse it well with water. When a battery leaked in
the battery holder, replace the batteries after wiping the leakage out.
• Make sure the plus and minus terminals are correctly aligned when loading a battery.
• Do not work on a battery; for example recharging or soldering.
• Do not keep the batteries put into the remote control when the remote control is not
used for a long while. Keep a battery in a dark, cool and dry place. Never expose a
battery to a fire or water.
• Obey the local laws on disposing a battery.
30º
30º
d11_01CP-A200_CO_ENG.indd 7 2009/12/22 9:37:54