beautypg.com

Dukane Data Video Projector 8103H User Manual

Page 14

background image

13

ENGLISH

12. Replacing the lamp (continued)

NOTE

• Please reset the lamp time only when you have replaced the lamp, for a suitable

indication about the lamp.

WARNING

High

Voltage

High

Temperature

High

Pressure

■ The projector uses a high-pressure mercury glass lamp. The lamp can break with a

loud bang, or burn out, if jolted or scratched, handled while hot, or worn over time. Note

that each lamp has a different lifetime, and some may burst or burn out soon after you

start using them. In addition, if the bulb bursts, it is possible for shards of glass to fly

into the lamp housing, and for gas containing mercury and dust containing fine particles

of glass to escape from the projector’s vent holes.

About disposal of a lamp: This product contains a mercury lamp; do not put it in a

trash. Dispose of it in accordance with environmental laws.

• For lamp recycling, go to www.lamprecycle.org (in the US).

• For product disposal, contact your local government agency or www.eiae.org (in the

US) or www.epsc.ca (in Canada).

For more information, call your dealer.

• If the lamp should break (it will male a loud bang when it does), unplug the

power cord from the outlet, and make sure to request a replacement lamp

from your dealer. Note that shards of glass could damage the projector’s

internals, or cause injury during handling, so please do not try to clean the

projector or replace the lamp yourself.

• If the lamp should break (it will make a loud bang when it does), ventilate the

room well, and make sure not to inhale the gas or fine particles that come out

from the projector's vent holes, and not to get them into your eyes or mouth.

• Before replacing the lamp, turn the projector off and unplug the power cord,

then wait for at least 45 minutes for the lamp to cool sufficiently. Handling

the lamp while hot can cause burns, as well as damaging the lamp.

• Never unscrew except the appointed (marked by an arrow) screw.

• Do not open the lamp cover while the projector is suspended from a ceiling

or somewhere over your head. This is dangerous, since if the lamp’s bulb

has broken, the shards will fall out when the cover is opened. In addition,

working in high places is dangerous, so ask your local dealer to have the

lamp replaced even if the bulb is not broken.

• Do not use the projector with the lamp cover removed. At the lamp replacing,

make sure that the screws are screwed in firmly. Loose screws could result in

damage or injury.

• Use only the lamp of the specified type. Use of a lamp that does not meet the lamp

specifications for this model could cause a fire, damage or shorten the life of this product.

• If the lamp breaks soon after the first time it is used, it is possible that there

are electrical problems elsewhere besides the lamp. If this happens, contact

your local dealer or service representative.

• Handle with care: jolting or scratching could cause the lamp bulb to burst during use.

• Using the lamp for long periods of time, could cause it dark, not to light up or to

burst. When the pictures appear dark, or when the color tone is poor, please replace

the lamp as soon as possible. Do not use old (used) lamps; this is a cause of breakage.

d11_01CP-A200_CO_ENG.indd 13

2009/12/22 9:37:58