Signamax 10/100 Industrial DIN-rail Mount Power over Ethernet Unmanaged Switches - Manual (Page 6)

Hardened PoE Ethernet Switch
6
Functional Description
• Meets IEC61000-6-2 EMC Generic Standard Immunity
for industrial environment.
• Supports IEEE802.3af Power over Ethernet (PoE)
Power Sourcing Equipment (PSE).
• Supports IEEE802.3/802.3u/802.3x. Auto-negotiation:
10/100Mbps, Full/Half-duplex, Auto-Negotiation, Auto
MDI/MDIX.
• 100Base-FX: Multi/Single mode SC or ST type, WDM
Single mode SC type.
• Supports 1024 MAC addresses. Provides 1M bits buffer
memory.
• Alarms for power and port link failure by relay output.
• Power Supplies: Redundant 48VDC Terminal Block
power inputs 100-240VAC external power supply.
• Operating voltage and Max. current consumption: 1.5A
@ 48VDC. Power consumption: 72W Max.
• -40 to 75 (
℃ ℃
-40℉ to 167℉) operating temperature
range. Tested for functional operation @ -40 to 85 ℃ ℃
(-40℉ to 185℉).
• Supports DIN-Rail, Panel, or Rack Mounting
installation.
Assembly, Startup, and Dismantling
• Assembly: Place the switch on the DIN rail from above
using the slot. Push the front of the switch toward the
mounting surface until it audibly snaps into place.
• Startup: Connect the supply voltage to start up the
switch via the terminal block.
• Dismantling: Pull out the lower edge and then remove
the switch from the DIN rail.