Signamax 10/100 Industrial DIN-rail Mount Unmanaged Switches - Manual (Page 13)

Hardened Ethernet Switch
13
Status LEDs
LED State Indication
POWER
Steady Switch is properly connected to power and turned on.
PWR1
PWR2
(Green)
Off Switch is not connected to power and is turned off.
FAULT
Steady
3. Power failure occurred.
4. Port failure occurred (when port fault alarm dip
switch is enabled).
FAULT
(Red)
Off
3. Power failure is not occurred.
4. Port failure is not occurred (when port fault alarm
dip switch is enabled).
3. Port fault alarm dip switch is disabled.
10/100BaseT/TX or 100BaseFX
Steady
A valid network connection established.
LNK stands for LINK.
LNK/ACT
(Green)
Flashing
Transmitting or receiving data.
ACT stands for ACTIVITY.
Steady Light solid yellow for a port transferring at 100Mbps.
100
(Yellow)
Off The port is transferring at 10Mbps If this LED is dark.
Physical Ports
This switch provides:
• Five 10/100BaseT/TX ports
• Four 10/100BaseT/TX ports + one 100BaseFX port
• Four 10/100BaseT/TX ports + two 100BaseFX ports
• Eight 10/100BaseT/TX ports
• Eight 10/100BaseT/TX ports + one 100BaseFX port
• Six 10/100BaseT/TX ports + two 100BaseFX ports
• Four 10/100BaseT/TX ports + four 100BaseFX ports
CONNECTIVITY
• RJ-45 connectors
• SC or ST connector on 100BaseFX fiber port