Signamax 100BaseFX Singlemode To Multimode Converters - Manual (Page 14)

Signamax
 100TX/FX to 100FX Media Converter
8 Installation
Connecting to Power
l This Converter is a plug-and-play device.
l Connect the supplied AC to DC power adapter to the
receptacle on the rear panel of the converter, and then
attach the plug into a standard AC outlet with a voltage
range from 100 to 260 volts AC.
Installation into the FO-065-1180 8-
Port Rackmount Chassis
The Converter can be fit into any of the expansion slots on
the specially-designed rackmount chassis.
l First, install the converter onto a carrier supplied with the
chassis:
Step 1- Unscrew the carrier from the desired expansion slot
on the chassis.
Step 2- Remove the four screws on the converter as shown
below.
Step 3- Fit the converter onto the carrier and use those four
screws to secure it.