Signamax 10/100/1000BaseT/TX to 100/1000Base SFP Switching Media Converter - Manual (Page 11)

Signamax
 Dual Rate SFP Media Converter
User’s Manual 9
Installing in a Chassis
The Converter can be fit into any of the expansion slots on a
special designed chassis.
•
First, install the converter onto a carrier supplied with the chassis:
Step 1- Unscrew the carrier from the desired expansion slot on the chassis.
Step 2-
Fit the converter onto the carrier.
•
When the converter is completely seated onto the carrier, insert the
carrier to the guide rails of the expansion slot.
•
Carefully slide in the carrier until it is fully and firmly fit the chassis.
Fasten the screws onto the carrier.
Never insert any converter into the chassis directly without using the
supplied carriers. The carriers allow secure and consistent placement
of the converters into the chassis’ backplane without causing any
damage.
Specifications
Applicable Standards IEEE802.3 10BaseT
IEEE802.3u 100BaseTX/FX
IEEE802.3ab 1000BaseT
IEEE802.3z 1000BaseSX/LX
Fixed Ports 1 10/100/1000BaseTX port
1 100Base and 1000Base dual rate SFP fiber
interface
Speed
10BaseT
100BaseTX/FX
1000BaseT
1000BaseSX/LX
10/20Mbps for half/full-duplex
100/200Mbps for half/full-duplex
2000Mbps for full-duplex
2000Mbps for full-duplex
Forwarding rate 14,880pps for 10Mbps
148,810pps for 100Mbps
1,488,100pps for 1000Mbps
LED Indicators PWR, LFS, LNKC, Copper Port Speed,
LNKF, SFP Port Speed
Dimensions 3.16” (W) x 4.3” (D) x 0.94” (H)
(80.3mm (W) × 109.2mm (D) × 23.8mm (H))
Weight 0.33lb. (150g)
Power External power adaptor 12VDC, 0.23A
Power Consumption 2.76W Max.
Operating Temperature 32℉ ~ 122℉ (0℃ ~ 50℃)
Storage Temperature 14℉ ~ 158℉ (-10℃ ~ 70℃)
Humidity 5 ~ 95%, non-condensing
Emissions FCC part 15 Class A, CE Mark Class A