Signamax 10/100/1000BaseT/TX to 100/1000Base SFP Switching Media Converter - Manual (Page 10)

Signamax
 Dual Rate SFP Media Converter
8 User’s Manual
Installation
This chapter gives step-by-step installation instructions for
the Converter.
Selecting a Site for the Equipment
As with any electric device, you should place the equipment
where it will not be subjected to extreme temperatures,
humidity, or electromagnetic interference. Specifically, the
site you select should meet the following requirements:
•
The ambient temperature should be between 32 and 122 degrees
Fahrenheit (0 to 50 degrees Celsius).
•
The relative humidity should be less than 95 percent, non-condensing.
•
Surrounding electrical devices should not exceed the electromagnetic
field (RFC) standards for IEC 801-3, Level 2 (3V/M) field strength.
•
Make sure that the equipment receives adequate ventilation. Do not
block the ventilation holes on each side of the equipment.
•
The power outlet should be within 1.8 meters of the product.
Connecting to Power
• This Converter is a plug-and-play device.
• Connect the supplied AC to DC power adaptor to the receptacle
on the rear panel of the converter, and then attach the plug into
a standard AC outlet with a voltage range from 100 to 240VAC.