Signamax 10/100BaseT/TX to 100BaseFX Converters w/USB Power Option - Manual (Page 9)

Signamax
™
10/100TX to 100FX Media Converter
6 User’s Manual
One-Channel Media Converter
Ports
The Converter provides one TX port and one FX port. For the
FX port, it provides options of multi-mode fiber using SC, ST,
VF-45, MT-RJ or LC connector, single-mode fiber using SC
connector, and WDM single-fiber (bi-direction) transceiver
using SC connector. For the TX port, it uses RJ-45 connector
and auto senses the speed of 10/100Mbps.
Port Settings
Port settings are made very simple by means of a DIP (Dual
Inline Package) switch at the rear panel of the module.
1 2 3 4 5 6
DIP switch
There are six pins on the DIP switch for port settings. Refer
to the table below for more details.
DIP
switch
No. Down (Default Setting) Up
1 Enable LFPT Disable LFPT LFPT:
link-fault-
pass-
through
2 Enable auto negotiation for
TX port Enable forced mode for
TX port
3 TX port forced to
100Mbps TX port forced to 10Mbps
4 TX port forced to full
duplex mode TX port forced to half
duplex mode
5 FX port forced to full
duplex mode FX port forced to half
duplex mode
6