Paxton Superchargers Dodge Viper User Manual

Page 30

10-2

P/N: 4809644

13DEC04 v2.0 03-05Viper(4809644v2

.0)

Tighten the hose clamps on the supercharger
inlet.

(2003-2004 vehicles) Remove the 1/2"

hose from the plastic TEE that connects the
intake manifold plenum to the rear of the
passenger side valve cover. Install the sup-
plied PCV valve as shown in Fig. 10-e1
using the supplied 3/8" and 1/2" hose and
1/2" - 3/8" barb reducer.

(2005 vehicles) Disconnect the rubber

elbow from the front of the driver’s side
valve cover. Install a short length of 3/8"
hose onto the inlet of the supplied PCV
valve. Install the rubber elbow over the 3/8"
hose and attach the other end of the PCV
valve to the valve cover using a short piece
of the supplied 1/2" hose. (See Fig. 10-e2.)

Fig. 10-e1 (2003-2004 Models)

Fig. 10-e2 (2005 Models)

Fig.

-d

Slide the supplied air filter into the air box
and use the supplied retainer to hold it in.
Install the four fasteners through the retainer
and air inlet and into the radiator shroud.
(See Fig. 10-d.)