Paxton Superchargers Dodge Viper - Manual (Page 24)

8-2
P/N: 4809644
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
13DEC04 v2.0 03-05Viper(4809644v2 .0)
Fig. 8-e
Fig. 8-c
Fig. 8-d
WATER PUMP
8. Using one of the supplied hose
menders, connect the long leg to the
hose attached to the top of the water
tank (trim as necessary).
9. Horn “A”
a.
Using the factory 90° horn bracket
with the 2.75" short leg as a tem-
plate, mark and drill a 5/32" pilot
hole approximately 5.5" forward of
the front sway-bar bracket bolt into
the frame rail. (See Fig. 8-c.)
b. Mount the factory horn and bracket
to the frame using the supplied
sheet metal screw.
10. Horn “B”
a. Use the remaining factory horn
bracket (With 1" short leg) as a
template.
b. Mark and drill two 1/4" holes
approximately .5" from each other
on the inner fender. (See Fig. 8-d.)
c. Remove the horn from the bracket
and reattach it to the inside of the
factory 90° bracket.
d. Secure the horn and bracket to the
inner fender using the supplied 1/4-
20 x 3/4" hex head bolt, washers
and nylock nut. (See Fig. 8-d.)
e. Verify that neither of the horn bod-
ies are touching other components.
f. Reattach the electrical plugs to the
horns and verify undistorted horn
tone.
g. Reinstall the plastic inspection
panel and the front wheel.
C. CAC WATER PUMP WIRING AND
INSTALLATION
1.
Cut a piece of the supplied hose to con-
nect the bottom of the reservoir to the
inlet of the water pump.
2. The pump outlet should point up and
toward the front of the vehicle. (See
Fig. 8-e.)