Paxton Superchargers Dodge Viper - Manual (Page 33)

10-1
P/N: 4809643
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
12APR04 v1.1 01-03Viper(4809643v1.1)
Section 10
AIR INLET DUCT INSTALLATION
10. AIR INLET DUCT INSTALLATION
A. Install the short end of the supplied 4” rub-
ber elbow onto the supercharger inlet.
B. Insert the large end of the supplied alu-
minum duct into the open end of the rubber
elbow.
C. Install the supplied conical air filter onto the
end of the aluminum duct. (See Fig.10-a.)
Fig. 10 -a
Fig. 10 -b
D. Orient the assembly to provide as much
clearance to the hood as possible.
E. Tighten a supplied hose clamp on each con-
nection.
F. Using the supplied 5/8" hose mender and
hose, connect the factory crankcase vent
hose to the 5/8" fitting installed in the bot-
tom of the supplied air inlet duct. Secure
with zip-ties.
G. For 1998 and later vehicles, remove the 3/8"
hose from the plastic TEE that connects the
intake manifold plenums to the crankcase.
Install the supplied PCV valve as shown in
Fig. 10-b using the supplied 3/8" hose.