Oil feed, Oil feed -1 – Paxton Superchargers Dodge Viper User Manual

Page 11

2-1

P/N: 4809643

12APR04 v1.1 01-03Viper(4809643v1.1)

Section 2

OIL FEED

Remove the oil pressure sender from the
front passenger side of the engine directly
above the oil filter.

Install the 1/8" NPT TEE in the oil sender
hole. Leave the TEE pointed forward. Install
the 1/8" NPT x -4 straight fitting in the front
of the TEE. Install the oil pressure sender in
the passenger side hole in the TEE and re-
attach the electrical plug. (See Fig. 2-a.)

Temporarily cover one end of the oil feed
line and protect it from debris until connect-
ing it to the supercharger.

Connect the open end of the oil feed line to
the -4 fitting. Use tie-wraps to secure the
line and protect it from kinking, abrasion
and high heat areas.

***IMPORTANT***

Use clean engine oil on the pipe threads. Teflon tape

and sealant is NOT recommended as it might loosen

and cause blockage of the small oil feed orifice result-

ing in supercharger failure.

Fig. 2-a

OIL FEED