Paxton Superchargers Dodge Viper User Manual

Page 27

9-3

P/N: 4809643

12APR04 v1.1 01-03Viper(4809643v1.1)

The supplied yellow wire will be used

as the “trigger” wire and should be con-

nected to terminal #85 using a slide

connector. The other end of the wire

will be connected in section 11.

Run the black wire from terminal #86

on the water pump relay to the

“ground” located beneath the power

brake booster or any other good ground

location.

Connect the fuse holder using a yellow

slide connector to terminal #30 on the

aftercooler pump relay and to the fuse

box power terminal on the front of the

fuse box using the supplied yellow ring

terminal connector.

Use the supplied black wire, ring termi-

Attach the water cooler to the installed

bracket and tighten so that the water

cooler is as far to the passenger’s side

as possible.

***CAUTION***

In the following step, use extreme care when drilling

through the oil cooler flange. If the drill bit slips or

goes through the hole too far, it will damage the radia-

tor, oil cooler or the AC condenser.

Use the unfastened bracket to serve as a

template to drill a 5/16" hole in the top

flange of the oil cooler. Install the sup-

plied 5/16" hardware and tighten.

Connect the outlet of the water pump to

the far side of the water cooler with the

installed 3/4" hose trimmed to fit.

Clamp each end. (See Fig. 9-h.)

Using supplied hardware, loosely attach

one of the supplied brackets to the pas-

senger’s side oil cooler mounting bolt.

(See Fig. 9-g.) Attach the other sup-

plied bracket to the supplied water

cooler using the supplied 1/4" hard-

ware.

Fig. 9-e

Fig. 9-f

Fig. 9-g

WATER

PUMP RELAY

PCM COVER

(WILL BE REMOVED LATER)

nal and slide connectors to extend the

water pump ground wire (brown wire

on Hella pump) to the same grounding

location used for the water pump relay.

Route the red wire from the water

pump to relay terminal #87. Using the

supplied butt connector, attach the red

wire to the positive wire on the water

pump (green wire on the Hella pump).

10. Install the supplied plastic wire loom

around the water pump power wires

and secure.

***NOTE***

Double check that all wires are connected to the proper

relay lugs.

Water Cooler Installation
1.

Using sealant, insert the 90° fittings in

the inlet and outlet of the water cooler

and point them towards each other.

Drill the air duct directly underneath

the bumper using a 1-1/8" hole saw on

both sides. Additionally, on the passen-

ger’s side, drill another hole next to the

radiator overflow tank so that the hose

can be routed smoothly from the CAC

to the water cooler.

Loop the supplied hose through each

hole and connect to the water cooler.

Install and tighten a supplied plastic

clamp on each hose connection. (See

Fig. 9-f.)

CLEARANCE BUMPER

AS NECESSARY