Paxton Superchargers Dodge Viper RT/10 User Manual

Page 27

9-3

P/N: 4809646

17FEB06 v2.0 92-96Viper(4809646v2.0)

The supplied yellow wire will be used

as the “trigger” wire and should be con-

nected to terminal #85 using a slide

connector. The other end of the wire

will be connected in section 11.

Run the black wire from terminal #86

on the water pump relay to the

“ground” located beneath it on the

vehicle’s frame.

Connect the fuse holder using a yellow

slide connector to terminal #30 on the

aftercooler pump relay and to the fuse

box power terminal on the front of the

fuse box using the supplied wire and

yellow ring terminal connector.

Use the supplied black wire, ring termi-

nal and butt connector to extend the

water pump ground wire (brown wire

on pump) to the same grounding loca-

tion used for the water pump relay

ground.

Route the red wire from the water

pump to relay terminal #87. Using the

supplied butt connector, attach the red

wire to the positive wire on the water

pump (green wire on the pump).

10. Install the supplied plastic wire loom

around the water pump power wires

and secure.

***NOTE***

Double check that all wires are connected to the proper

relay lugs.

Water Cooler Installation
1.

Remove the two screws securing the

hood release handle to the bumper.

Using sealant, insert the 90° fittings in

the inlet and outlet of the water cooler

and point them towards each other.

Attach the water cooler to the installed

bracket and tighten so that the water

cooler is as far to the passenger’s side

as possible.

***CAUTION***

In the following step, use extreme care when drilling

through the oil cooler flange. If the drill bit slips or

goes through the hole too far, it will damage the radia-

tor, oil cooler or the AC condenser.

Use the unfastened bracket to serve as a

template to drill a 5/16" hole in the top

flange of the oil cooler. Install the sup-

plied 5/16" hardware and tighten.

Connect the outlet of the water pump to

the far side of the water cooler with the

installed 3/4" hose trimmed to fit by

routing a section of hose through the

bumper. Clamp each end.

Route a 3/4" hose from the remaining

fitting on the water cooler between the

radiator and the passenger’s side frame

rail, connect to the 90° fitting installed

on the CAC.

Using supplied hardware, loosely attach

one of the supplied brackets to the pas-

senger’s side oil cooler mounting bolt.

(See Fig. 9-g.) Attach the other bracket

to the water cooler using the supplied

1/4" hardware.

*** NOTE ***

1996 Model Year vehicles use different water cooler

mounting brackets than the earlier cars, make sure to

use the correct pair of brackets as indicated in Figs.

9-f, 9-g.

Fig. 9-f / ('96 Water Cooler Bracket Shown)

Fig. 9-g / ('92-'95 Water Cooler Bracket Shown)