Paxton Superchargers Dodge Viper RT/10 - Manual (Page 23)

8-1
P/N: 4809646
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
17FEB06 v2.0 92-96Viper(4809646v2.0)
Section 8
SUPERCHARGER INSTALLATION
8. SUPERCHARGER INSTALLATION
Fig. 8-a
Fig. 8-b
Fig. 8-c
A. Install the supplied 1/2" oil drain hose onto
the barb fitting on the bottom of the super-
charger and secure with the supplied #8 hose
clamp.
B. Attach the supercharger mounting plate to
the supercharger. Use five of the supplied
3/8" x 1.25" screws and washers. (See Fig.
8-a.)
C. Install the spring tensioner onto the super-
charger mounting plate using the supplied
3/8" x 2.25" screw and washer. (See Fig.
8-a.) Install the spring tensioner into the low
mounting position.
D. Install the supercharger drive belt onto the
supercharger pulley so that the back side
will ride on the spring tensioner idler. (See
Fig. 7-c for belt routing.)
***NOTE***
When installing the supercharger assembly, keep in
mind that the supercharger belt will need to be routed
around the crank pulley and mounting bracket standoff.
(See Fig. 8-c.)
* SUPERCHARGER
AND SPRING
TENSIONER OMITTED
FOR CLARITY
E. Attach the supercharger plate assembly to
the mounting bracket using the supplied
3/8"x 1-3/4" screws and washers. Install the
supplied 4" spacers into the two remaining
supercharger mounting plate locations and
install the supplied 3/8" x 5-3/4" screws and
washers. Tighten the screws. (See Fig. 8-b.)
SPRING TENSIONER
IDLER
BELT MUST ENCIRCLE
LEFTMOST MOUNTING
BRACKET STANDOFF
SUPERCHARGER
PULLEY
SUPPLIED 8-RIB
CRANK PULLEY