Oil feed, Oil feed -1 – Paxton Superchargers Dodge Viper RT/10 User Manual

Page 11

2-1

P/N: 4809646

17FEB06 v2.0 92-96Viper(4809646v2.0)

Section 2

OIL FEED

Remove the oil pressure sender from the
front passenger side of the engine directly
above the oil filter.

Install the 1/8"NPT TEE in the oil sender
hole. Leave the TEE pointed up. Install the
1/8"NPT x -4 90° fitting in the top of the
TEE. Install the oil pressure sender in the
front hole in the TEE and re-attach the elec-
trical plug. (See Fig. 2-a.)

Temporarily cover one end of the oil feed
line and protect it from debris until connect-
ing it to the supercharger.

Connect the open end of the oil feed line to
the -4 fitting. Use tie-wraps to secure the
line and protect it from kinking, abrasion
and high heat areas.

***IMPORTANT***

Use clean engine oil on the pipe threads. Teflon tape

and sealant is NOT recommended as it might loosen

and cause blockage of the small oil feed orifice result-

ing in supercharger failure.

OIL FEED

Fig. 2-a