One Systems POPS SUBa - Manual (Page 4)

Read all of the instructions included in this manual
NOTE: The AC mains supply end of the POPS Sub power cable MUST be
plugged into a supply source that has a GROUND FAULT CIRCUIT
INTERRUPTER (GFCI). The 115 VAC version is supplied with an in-line GFCI.
The 230 VAC version is supplied with a Portable Residual Current Device
(PRCD). In Europe, these devices are also referred to as Residual Current
Devices or Residual Current Circuit Breakers.
NOTE: THE RESET ON THIS DEVICE SHOULD BE TESTED TO VERIFY
PROPER OPERATION OF THE SAFETY DEVICE!
The POPS Sub is supplied with an “in line” GFCI device for use in countries that
use 115VAC. DO NOT bypass this device or disable. The end of the AC Mains
cable that is plugged in to the AC Mains supply must be in a dry condition.
The POPS Sub is supplied with an “in line” PRCD device for use in countries that
use 230VAC. DO NOT bypass this device or disable. The end of the AC Mains
cable that is plugged in to the AC Mains supply must be in a dry condition.
NOTE: If a hard-wired GFCI or PRCD device is already located at the AC Mains
source connection then the “in line” devices may be removed. THIS MUST BE
DONE BY A LICSENSED ELECTRICIAN THAT IS FAMILIAR WITH ALL LOCAL
AND NATIONAL ELECTRICAL CODES AND PRACTICES.
DO NOT BYPASS THE GFCI OR PRCD DEVICE UNLESS YOU ARE FULLY
LICSENSED AND QUALIFIED TO DO SO!
Copies of this manual should be retained by both the system installer AND end
user.
 This manual must be read and understood and ALL warnings must be
followed.
 Follow all instructions to insure optimal product performance.
 Copies of this manual should be retained by both the system installer AND
end user.
 This manual must be read and understood and ALL warnings must be
followed.
 Follow all instructions to insure optimal product performance.