One Systems POPS SUBa - Manual (Page 14)

The wiring is also shown below for the POPSSub and POPS15.
From Mixer Console
Output to POPS Sub
Input
POPS Sub
High Pass Output
to POPS 15
Input
POPS 15 Input
As noted above, the mixing console’s output is wired to the POPS Sub’s input.
The POPS Sub’s High-Pass Output is wired to the input of the POPS 15. The
XLR connectors supplied with POPS15 and POPSSub must be used for these
connections. DO NOT SUBSTITUTE!
DO NOT USE THE CONNECTOR IF MOISTURE IS PRESENT IN THE PANEL
PORTION OF THE XLR CONNECTOR. THE PANEL’S CONNECTOR MUST BE
DRIED PRIOR TO CONNECTION!
WARNING: DO NOT SUBSTITUTE XLR CABLE END CONNECTORS.
FAILURE TO USE NEUTRIK NC3FXX-HD-D CABLE END CONNECTORS WILL
COMPROMISE THE WATER / MOISTURE RATING OF THE POPSSUB AND
MAY RESULT IN UNSAFE CONDITIONS. NEUTRIK NC3FXX-HD-D
CONNECTORS MUST BE USED FOR ALL CONNECTIONS ON THE
POPSSUB.