One Systems POPS SUBa - Manual (Page 10)

INSURE THAT THE AC MAINS CABLE IS SECURLY CONNECTED AND IS
“LOCKED” INTO POSTION. DO NOT USE THE POPSSub IF THE AC MAINS
CONNECTOR IS NOT SECURLY-MATED TO THE AMPLIFIER MODULE!
DO NOT CONNECT THE AC MAINS END OF THE AC MAINS CABLE IN AN
AREA THAT IS WET OR SUBJECT TO CONDENSATION OR DAMP
CONDITIONS!
The AC Mains end of the cable assembly uses an “in-line” GFCI device (115 V
AC) or a PRCD device (230 V AC). DO NOT disconnect this device!
To disconnect the cable end of the AC mains connector, pull back on the collar of
the cable’s end connector in the direction shown on the connector. While pulling
back on the collar, pull the cable end connector away from the chassis
connector.
NOTE: ALWAYS turn off the AC mains power BEFORE attempting to disconnect
the AC mains cable from POPSSub’s amplifier module!
The AC mains supply end of the cable is shown in the image below.
Cable end AC Mains end
(connected to POPS Sub)
Once the AC mains cable is connected to POPSSub’s electronics, the other end
of the AC mains cable may be connected to the AC mains supply. This end of the
AC mains cable is a standard connector and MUST be connected in an area that
is DRY. The figure above represents both ends of the AC mains cable. The
connector on the left side of this figure is the IP 68-rated cable end that should be